|
|
|
|
Boring Holes on TilesMany ceramic tiles have a slightly flexible central core and a slender tough glossy appearance on the outside. These tiles are simple to drill all through the way back. The simplest tiles to bore are those that are extremely soft. These are usually manufactured for use in the construction of homes in the southwestern part of the USA. Normally, they do not have a glossy appearance or a very thin radiant finish. Tile Solidity Tile hardness is a useful characteristic of the type of clay and its silica content is responsible for forming the tile. The hardness of the tile is relatively proportional to the amount of time the tile is placed in the burning furnace and the degree of temperature inside it. A very hot temperature and prolonged burning time can make a rock-solid piece. Glass and porcelain tiles are very stylish today. These products are so hard, which make them very difficult to drill. A good tool to use for drilling is the sharp carbide drill. In using this type of drill, lubricating or watering is needed to keep the bit from moving over the spot where the hole is to be drilled. A diamond-coated bit will go through porcelain or glass more quickly than carbide, but these bits cost too much. Drilling Tips An ordinary carbide bit is suitable for drilling softer tiles. Never use a hammer drill because its very fast setting may crack the tile. A trick would be to set the drill on a slow speed at the start and carefully drill through the exterior of the thin finish. Once the bit reaches the soft center, it will rapidly go through the softer fired part of the clay. Do not use too much force when starting to drill. The drill and bit may slide from the targeted spot and scrape the tile. Scratching or cracking a tile is the worst mistake you can ever make when drilling a hole on it. When this occurs, a considerate amount of work is needed to put the pieces of a broken tile. Drilling should be done carefully and patiently.
, Using Ceramic Tiles.com |
